Huawei OceanStor Dorado V6
Monitor hardware health, capacity, controller load, temperatures, selected ports and LUN latency of your Huawei OceanStor Dorado V6 via SNMP.
The Huawei OceanStor Dorado V6 check monitors a Huawei OceanStor Dorado V6 storage system via SNMP: the hardware health of storage pools, disks, controllers, power supplies, fans, batteries and enclosures, the used capacity of storage pools, controller CPU and memory usage, disk and enclosure temperatures, explicitly selected Ethernet and FC ports, and LUN latency and IOPS. It runs network-based on an octoja agent on Windows, Linux, or macOS (x64 and Arm64) that can reach the storage system over the network, every 5 minutes by default.
Prerequisites
- SNMP is enabled on the OceanStor system (v2c or v3), and the executing agent can reach it on the SNMP port.
- You need the Monitoring Check Management permission.
Steps
- Go to Devices and open the device whose agent can reach the storage system.
- Click the Checks tab → Add Check → Huawei OceanStor Dorado V6.
- Enter the storage system under Host and provide the SNMP credentials.
- Under Ports to monitor, enter the exact location names of the ports to monitor. Without entries, the check monitors no ports.
- Adjust the thresholds if needed and click Add Check.
You can also assign the check to a network device; octoja then fills Host with that device's IP address, and the agent set as Monitoring device runs the query. SNMP settings stored on the network device take precedence over those in the check.
Settings
The editor lists the thresholds under Alert thresholds. They apply immediately to each reading, without a sustained-duration requirement, as soon as the reading reaches them. If a warning threshold is higher than its critical threshold, the check swaps the two. If a threshold is outside its allowed range, the check reports Failure.
Results
The overall result is the worst status across all readings.
- The check uses SNMP polling only. It does not evaluate traps, error counters, or running statuses.
- The check calculates a storage pool's used capacity from its total and free capacity.
- IOPS per LUN are shown for information only and are not evaluated. LUNs appear with their SNMP index.
The result shows the number of checked values and lists every value that is not OK, each with component, metric, value and, where applicable, threshold.
See also: Assign checks with config packages
Was this helpful?
More in Storage & files
Mount Point Free SpaceCeph Cluster HealthCeph Node DaemonsCeph Storage & PerformanceStill need help? Ask the team